[x-y]

yesterday one of my old mmm stoped after a small jump ....... nothing light of the esc work ......... after 3 hours or check all the components/solders we decided the esc is dead :p

angered I connected a 6.6v lifepo batt at the receiver without disconnect the red wire of the esc (the wire of disconnect for use a extra batt with the receiver or for use external bec)

for experience I was sure the esc will burn and make white smoke (isnt the first mmm I burn) ....... after see the white smoke, I retired the piece of make the white smoke and I tried again at connect the same config ........ 3 wires esc + external batt 6.6v

AWESOME........ without this piece and using an extra 6.6v bat for the receiver, the esc works perfect and we spent +60min of batts ........

INCREDIBLE BUT TRUE

regards ;)