RC-Monster Forums - View Single Post - Soldering/Wiring/Ice ESC/Bullets PROBLEMS & QUERIES

sikeston34m · 04.19.2011, 07:59 AM

Large Wires can be a pain in the butt.

There are two things you can do to make the over sized wires fit your bullet connectors:

#1. Heat up the soldered end and crimp it while it's still hot. I use a crimp tool that produces a rounded crimp. This reduces the overall diameter of the soldered end.

#2. Sand it down to size. I don't like to do this. But it will work.

Your BEC will plug into the receiver just like the servos do.

I would power the BEC at the ESC bullets.

I hope this helps. Good Luck with your build.

	(#2)
sikeston34m RC-Monster Brushless Offline Posts: 2,085 Join Date: Sep 2007	04.19.2011, 07:59 AM Large Wires can be a pain in the butt. There are two things you can do to make the over sized wires fit your bullet connectors: #1. Heat up the soldered end and crimp it while it's still hot. I use a crimp tool that produces a rounded crimp. This reduces the overall diameter of the soldered end. #2. Sand it down to size. I don't like to do this. But it will work. Your BEC will plug into the receiver just like the servos do. I would power the BEC at the ESC bullets. I hope this helps. Good Luck with your build.