RC-Monster Forums - View Single Post

RC-NUT · 11.27.2011, 10:08 PM

The LST2 shafts are the same length for the front and rear. It would have been sweet if they fit.

This is going to be a standard length build.

Design #2 is under way. I've flipped the motor 180 deg so it's now in the front of the truck. I think that will be better for weight distribution. I'm also working on a new bracket layout. The heavy duty Flux CVD will be in the rear and a 110mm dogbone will be in the front.

	(#10)
RC-NUT RC-Monster Carbon Fiber Offline Posts: 121 Join Date: Oct 2006 Location: SANDOWN, NH	11.27.2011, 10:08 PM The LST2 shafts are the same length for the front and rear. It would have been sweet if they fit. This is going to be a standard length build. Design #2 is under way. I've flipped the motor 180 deg so it's now in the front of the truck. I think that will be better for weight distribution. I'm also working on a new bracket layout. The heavy duty Flux CVD will be in the rear and a 110mm dogbone will be in the front.