RC-Monster Forums - View Single Post

rawfuls · 12.23.2011, 05:13 PM

I ended up using the main idea, got a drywall screw, trimmed it to size, drilled a hole SLIGHTLY smaller than the diameter of the drywall screw (and not the thread), screwed it in, cut off the cap, and did the same for the foot.

Worked well, just slightly crooked, but works fine!

The piece isn't a normal piece, it has the theme of "Gangsters vs. Robbers", and the Gangster piece is a little hard to find, but hey, now I don't need to shop!

Seriously, took like 15 minutes, 5 of which I was trying to find a good DeWalt battery to use (by the way, all of ours are dead now..), and couldn't so I relied on a cheap WallyWorld drill...

	(#7)
rawfuls roofles. Offline Posts: 1,982 Join Date: Oct 2008 Location: Woodland Hills, CA	12.23.2011, 05:13 PM I ended up using the main idea, got a drywall screw, trimmed it to size, drilled a hole SLIGHTLY smaller than the diameter of the drywall screw (and not the thread), screwed it in, cut off the cap, and did the same for the foot. Worked well, just slightly crooked, but works fine! The piece isn't a normal piece, it has the theme of "Gangsters vs. Robbers", and the Gangster piece is a little hard to find, but hey, now I don't need to shop! Seriously, took like 15 minutes, 5 of which I was trying to find a good DeWalt battery to use (by the way, all of ours are dead now..), and couldn't so I relied on a cheap WallyWorld drill...