RC-Monster Forums - View Single Post

scarletboa · 02:28 AM

just go for it!

if something does go wrong, it's not really a big loss. i would just keep a close eye on it to be sure. that's what i did when i put a sidewinder sct combo in an e-maxx. i kept a close eye on it while it was geared very low and it actually worked out very nicely. then, i geared it for 35mph and ran 3s until the esc thermalled and i swapped it for a mmp and it still ran fine. the motor still never broke 150F.

	(#2)
scarletboa RC-Monster Aluminum Offline Posts: 929 Join Date: Mar 2009 Location: Las Vegas NV	12.27.2011, 02:26 AM just go for it! if something does go wrong, it's not really a big loss. i would just keep a close eye on it to be sure. that's what i did when i put a sidewinder sct combo in an e-maxx. i kept a close eye on it while it was geared very low and it actually worked out very nicely. then, i geared it for 35mph and ran 3s until the esc thermalled and i swapped it for a mmp and it still ran fine. the motor still never broke 150F. They say a good mechanic only needs 2 tools - WD40 & Duct tape. If it moves, and its not supposed to, duct tape. If it doesn't move, and its supposed to, WD40. Last edited by scarletboa; 12.27.2011 at 02:28 AM.