RC-Monster Forums - View Single Post

plumslow · 12.29.2011, 08:37 PM

I would like to see them install female 4mm bullets all the way around like the had on the Mamba Monster. The 4mm would allow you to use them as solder joints if you wanted or use bullets if that was your choice. The 4mm would need to have a decent heat sink to prevent melting off of the board.

	(#2)
plumslow RC-Monster Stock Offline Posts: 15 Join Date: Jun 2007	12.29.2011, 08:37 PM I would like to see them install female 4mm bullets all the way around like the had on the Mamba Monster. The 4mm would allow you to use them as solder joints if you wanted or use bullets if that was your choice. The 4mm would need to have a decent heat sink to prevent melting off of the board.