RC-Monster Forums - View Single Post - Going to the dark side. Jammin X1 CRT Conversion.

magman · 10:50 AM

I noticed you dremeled out part of the chassis for the spur....another option and what I did under my center diff mount is install some small washers. I needed more clearance for the 1520 CC motor I am running in my mbx5t. Nice job.

In looking at the same pic again, I would definitely add washers under you center diff mount just to bring it up a bit more

	(#8)
magman RC-Monster Dual Brushless Offline Posts: 4,236 Join Date: Dec 2007 Location: Cape Cod, Mass.	01.07.2012, 10:47 AM I noticed you dremeled out part of the chassis for the spur....another option and what I did under my center diff mount is install some small washers. I needed more clearance for the 1520 CC motor I am running in my mbx5t. Nice job. In looking at the same pic again, I would definitely add washers under you center diff mount just to bring it up a bit more 1. MBX-6 T8 1900KV, RX8 ON 4S 2. MBX-5T 1520, MMM ON 5S 3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S 4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S 5. TEN T 2650 T8, MMP ON 3S Last edited by magman; 01.07.2012 at 10:50 AM.