RC-Monster Forums - View Single Post - Getting the Pinion to stay on the motor shaft?

Chainsaw10 · 10:05 PM

What I did with my MT4-g3 is dremel a small divot in the motor shaft where the set screw contacts it.... This let's the set screw sit a tad deeper. Red loctite should also work. There are also pinions with two set screws that will do the trick..

Here's one
http://www.ebay.com/itm/NEW-Tekno-R-...6#ht_626wt_698

	(#8)
Chainsaw10 RC-Monster Stock Offline Posts: 38 Join Date: Oct 2011	01.09.2012, 10:02 PM What I did with my MT4-g3 is dremel a small divot in the motor shaft where the set screw contacts it.... This let's the set screw sit a tad deeper. Red loctite should also work. There are also pinions with two set screws that will do the trick.. Here's one http://www.ebay.com/itm/NEW-Tekno-R-...6#ht_626wt_698 Last edited by Chainsaw10; 01.09.2012 at 10:05 PM.