RC-Monster Forums - View Single Post

Revorocks · 02.11.2012, 09:16 PM

Additionally I bought an RC Monster motor mount, 30T pinion and drive cups.

Did a test fit of the 1717 with the new mount, fitted very nicely after using some washers.

MMM, SS screws :D

Cleaned out the centre diff while I was at it.

Just clears the chassis.

Now the MMM isn't going to be up for a speed run with a 1717, so I also bought a Mamba XL2 :D

I've got a new shell on the way,as well as some GRP Rally tyres, these are supposed to be very good for speed runs and hold up well above 100mph.

So that's where it is now, currently waiting on the machining, a custom pinion, and then I need to get some custom length driveshafts made, or shorten the current ones. Anyone know the best way of doing that?

	(#3)
Revorocks RC-Monster Stock Offline Posts: 44 Join Date: Sep 2011 Location: Sussex, UK	02.11.2012, 09:16 PM Additionally I bought an RC Monster motor mount, 30T pinion and drive cups. Did a test fit of the 1717 with the new mount, fitted very nicely after using some washers. MMM, SS screws :D Cleaned out the centre diff while I was at it. Just clears the chassis. Now the MMM isn't going to be up for a speed run with a 1717, so I also bought a Mamba XL2 :D I've got a new shell on the way,as well as some GRP Rally tyres, these are supposed to be very good for speed runs and hold up well above 100mph. So that's where it is now, currently waiting on the machining, a custom pinion, and then I need to get some custom length driveshafts made, or shorten the current ones. Anyone know the best way of doing that? E-Revo Brushless MMM + Neu 1515 5S Hyper 7e MMM + Neu 1717 6S Speed Project