RC-Monster Forums - View Single Post - Help a noob? Please. BEC, ESC, New Servo for Flux.

_paralyzed_ · 11.20.2012, 10:46 PM

Yes, use the castle link to adjust the output of the bec.

Since you have a spectrum rx you could just wire it directly to the rx (NO bec) and pull the red wire from the esc. This would be the easiest way.

If you do as suicideneil diagramed you are correct, you leave the red wire from the esc intact.

	(#4)
_paralyzed_ working on a brushless for my wheelchair..... Offline Posts: 4,890 Join Date: Mar 2007 Location: minnesnowta	11.20.2012, 10:46 PM Yes, use the castle link to adjust the output of the bec. Since you have a spectrum rx you could just wire it directly to the rx (NO bec) and pull the red wire from the esc. This would be the easiest way. If you do as suicideneil diagramed you are correct, you leave the red wire from the esc intact. _______________________________________ It's "Dr. _paralyzed_" actually. Not like with a PhD, but Doctor like in Dr. Pepper.