RC-Monster Forums - View Single Post

Blazerss · 12.17.2012, 08:01 PM

Thanks for the help and PM's guys. I contacted FLM and they said they will have 2 new ones in the mail tomorrow. I'm still going to make one at work tomorrow in stainless or just steel and harden it. These have to be done and RTR Christmas morning and I don't really have faith that the USPS will have it here by then, so better to be safe than sorry.

The second issue I had was with the alignment pin hole in front bulks of the second truck. It was .003 too small and the alignment pin wouldn't slide in. So I took them to work today and put them on the mill and reamed them to the correct size and the pins fit perfect now.

	(#4)
Blazerss RC-Monster Carbon Fiber Offline Posts: 209 Join Date: Dec 2011 Location: Atlanta, GA	12.17.2012, 08:01 PM Thanks for the help and PM's guys. I contacted FLM and they said they will have 2 new ones in the mail tomorrow. I'm still going to make one at work tomorrow in stainless or just steel and harden it. These have to be done and RTR Christmas morning and I don't really have faith that the USPS will have it here by then, so better to be safe than sorry. The second issue I had was with the alignment pin hole in front bulks of the second truck. It was .003 too small and the alignment pin wouldn't slide in. So I took them to work today and put them on the mill and reamed them to the correct size and the pins fit perfect now.