Hi all,
Have really enjoyed the discussion we have had recently on the Gorillamaxx line of products, so thought I would document a build thread for a truck I am really excited to build.
I always like to start with a pic showing a pile of parts, so here goes:
Gorillamaxx G1 Chassis
Gorillamaxx G3 Suspension Arms & Towers
UE Gen IV Servo Saver
UE Superlite Cases
UE 6mm CVDs
UE Spyder 6 Diffs Front & Rear
Centralemaxx 16mm Knuckles
Centralemaxx 17mm Hub Adaptors
Centralemaxx 17mm Washers
Proline Maxx Powerstrokes
Kmaxx Kustom Powerstroke Spring Retainers
Kmaxx Kustom Powerstroke Spring Seperators
SweetStrobe Bulkhead Braces
I have a set of GARC 7075 Bulks being drilled & tapped for Ejector Pins at the moment as well. Once they are shipped back to me from the states, this build can really get started.
Parts I have planned for this truck that I do not yet have are a FLM Half Case Tranny used with a G1 Single Speed Plate. If anyone has either of these pieces to help me with this build let me know, as I think they would be the icing on the cake so to speak. I am not holding my breath, but you never know unless you ask haha. Feel free to let me know what you guys think, here a few close up of the parts I have for this build.
Kmax Kustom Powerstroke Spring Seperators & Retainers
Gorillamaxx G3 Suspension Centralemaxx 16mm Knuckles
SweetStrobe Bulkhead Braces
UE Gen IV ServoSaver & Gorillamaxx G3 Tower
Centralemaxx 17mm Hub Adaptors
