RC-Monster Forums - View Single Post

sjcrss · 04.11.2006, 09:08 PM

well , I have some good news.....after heating the arm in the oven @ 350 Degrees... for about 30 min, I was able to straighten the arm out... to the point of where it's barely noticeable.....which is good.....so now I'm back in business.....for now......But now I'm on the lookout for a 2 front arms as a backup or wait for UE high Impact arms to come out again....thanks for the suggestion Mike L....

	(#17)
sjcrss Hyper 7 Erevo Center Diff Offline Posts: 1,195 Join Date: Dec 2005 Location: CNY (Syracuse/Binghampton area)	04.11.2006, 09:08 PM well , I have some good news.....after heating the arm in the oven @ 350 Degrees... for about 30 min, I was able to straighten the arm out... to the point of where it's barely noticeable.....which is good.....so now I'm back in business.....for now......But now I'm on the lookout for a 2 front arms as a backup or wait for UE high Impact arms to come out again....thanks for the suggestion Mike L....