RC-Monster Forums - View Single Post

09:33 PM

I purchased this wheelie bar. After a while the WB started pushing up against the skid plate. It made far very long wheelies, but was ruining the tires and bending the bulkhead screws.

Next, I used a long screw rod with four tires and it really bent up everything.

Here is the threaded rod used with the four tires. Notice the 2 WB tires :005:

So here is my solution. I used shorter bolts and nuts to secure the WB to the bulks and went with two tires.

Notice I removed the bulkhead braces. Do you guys think this will cause a problem with my hybrid bulkheads?

	(#1)
capitol Guest Posts: n/a	wheelie bar problems and solution - 07.27.2006, 09:26 PM I purchased this wheelie bar. After a while the WB started pushing up against the skid plate. It made far very long wheelies, but was ruining the tires and bending the bulkhead screws. Next, I used a long screw rod with four tires and it really bent up everything. Here is the threaded rod used with the four tires. Notice the 2 WB tires :005: So here is my solution. I used shorter bolts and nuts to secure the WB to the bulks and went with two tires. Notice I removed the bulkhead braces. Do you guys think this will cause a problem with my hybrid bulkheads? Last edited by capitol; 07.27.2006 at 09:33 PM.