RC-Monster Forums - View Single Post

GorillaMaxx360 · **A question -** 11.22.2006, 06:52 PM

Were(maby tell me or show link thanks) and how much are the 40mm fans that work with the cnc machined esc cooling heat sink. [URL="http://www.rc-monster.com/proddetail.php?prod=RCM008"] also this fan that you direct me to or recommend to get, does it have low enough voltage to not make a noticable difference in run times. Also if it is three pronged i just use a y joint right! but if it is not 3 prong (like servo useualy uses) how do i make it 3 prong or is there a better way to wire it. Also a pic who has this setup. It would be nice to se

	(#1)
GorillaMaxx360 Always Willing to Obtain More Knowledge Offline Posts: 1,482 Join Date: Oct 2006 Location: Chicago	A question - 11.22.2006, 06:52 PM Were(maby tell me or show link thanks) and how much are the 40mm fans that work with the cnc machined esc cooling heat sink. [URL="http://www.rc-monster.com/proddetail.php?prod=RCM008"] also this fan that you direct me to or recommend to get, does it have low enough voltage to not make a noticable difference in run times. Also if it is three pronged i just use a y joint right! but if it is not 3 prong (like servo useualy uses) how do i make it 3 prong or is there a better way to wire it. Also a pic who has this setup. It would be nice to se