RC-Monster Forums - View Single Post

HotnCold · 04:07 PM

First off - welcome to the forums - The wheel hex seems to strip when they are a bit loose - that has been my experiences with the dredded hex slip - The metal hexes will not strip - so that should cure your problem - but till then - make sure that the wheel nuts stay tight - I locktited mine ( till i got the metal ones )- just a little goes a long way with the locktite too - or you could go the bigger hex route - 14mm - .. Good luck and once again - Welcome....

	(#1)
HotnCold RC-Monster Admin Offline Posts: 1,065 Join Date: Dec 2004 Location: RC-Monster Store....Where else?	12.15.2006, 04:03 PM First off - welcome to the forums - The wheel hex seems to strip when they are a bit loose - that has been my experiences with the dredded hex slip - The metal hexes will not strip - so that should cure your problem - but till then - make sure that the wheel nuts stay tight - I locktited mine ( till i got the metal ones )- just a little goes a long way with the locktite too - or you could go the bigger hex route - 14mm - .. Good luck and once again - Welcome.... Hows that "Hope and Change" working out for Ya??? Last edited by HotnCold; 12.15.2006 at 04:07 PM.