RC-Monster Forums - View Single Post

Re~Mix · 01:11 PM

Hello, I have been having a bit of trouble programming the quark 33 pro car 1/18th controller. I have everything set up properly and I programmed the nuetral position on the transmitter and such. All is well until I turn it on about 20 minutes later, all I get it is a continuous beeping alarm? I looked in the manual and troubleshooting on their site, and no luck figuring out the issue yet. It won't even let me reprogram the esc.

Edit: I have the female plugs on the motor and the male on the esc... could this be causing the problem?

	(#1)
Re~Mix ¡Go Baby Go! Offline Posts: 361 Join Date: Apr 2005 Location: Minnesota	Quark Woes.. - 12.29.2006, 01:09 PM Hello, I have been having a bit of trouble programming the quark 33 pro car 1/18th controller. I have everything set up properly and I programmed the nuetral position on the transmitter and such. All is well until I turn it on about 20 minutes later, all I get it is a continuous beeping alarm? I looked in the manual and troubleshooting on their site, and no luck figuring out the issue yet. It won't even let me reprogram the esc. Edit: I have the female plugs on the motor and the male on the esc... could this be causing the problem? RC18T FT - Quark Castle Creations Airtronics IB Last edited by Re~Mix; 12.29.2006 at 01:11 PM.