RC-Monster Forums - View Single Post

BrianG · 01.14.2007, 12:50 PM

I waited until my Quark was out of warranty before disassembling it to remove the thermal pads and epoxy the internal plates. I think they use thermal pads because they DO stick, but are removeable if needed for repair work. An epoxied board isn't coming apart without breaking something!

I was a little nervous when I did it; after all, it was a $280 ESC! But now it's done, I'm glad I did it.

	(#7)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	01.14.2007, 12:50 PM I waited until my Quark was out of warranty before disassembling it to remove the thermal pads and epoxy the internal plates. I think they use thermal pads because they DO stick, but are removeable if needed for repair work. An epoxied board isn't coming apart without breaking something! I was a little nervous when I did it; after all, it was a $280 ESC! But now it's done, I'm glad I did it.