RC-Monster Forums - View Single Post

BrianG · 01.30.2007, 02:56 AM

PM answered and thanks. :)

Well, I dremeled out the mount slightly to get the motor to fit right. It's amazing what less than 0.5mm will do! Now I can use my 14T pinion. Yay!

I ended up ordering those Ofna gaskets at Tower. The diff still isn't leaking, but I might as well do it right, especially now when everything is apart.

I'm still having a heck of a time trying to fit the Quark on there! What's tough is trying to find a position that will make wiring neater while keeping it away from the body enough so it won't get abused if the buggy lands on its lid. But, I think I have a plan. :) So I also ordered some 1/16" thick 6061 aluminum sheet (pretty good price at Tower too). If it turns out like I think it will, it should be pretty.

	(#157)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	01.30.2007, 02:56 AM PM answered and thanks. :) Well, I dremeled out the mount slightly to get the motor to fit right. It's amazing what less than 0.5mm will do! Now I can use my 14T pinion. Yay! I ended up ordering those Ofna gaskets at Tower. The diff still isn't leaking, but I might as well do it right, especially now when everything is apart. I'm still having a heck of a time trying to fit the Quark on there! What's tough is trying to find a position that will make wiring neater while keeping it away from the body enough so it won't get abused if the buggy lands on its lid. But, I think I have a plan. :) So I also ordered some 1/16" thick 6061 aluminum sheet (pretty good price at Tower too). If it turns out like I think it will, it should be pretty.