RC-Monster Forums - View Single Post

BrianG · 02.19.2007, 05:28 PM

It's not hard to dremel a flat spot on the shaft. Just make sure the bearing and screw holes are covered so metal dust doesn't get in there. I just held my Neu shft with two fingers and used a small sanding drum on the dremel. Took about 1 minute.

IIRC, If you re-wire the LMTs from D to Y, you reduce the kv by a factor of 1.73 (I think). This allows you to run higher voltage in Y, and lower voltage in D and keep the same rpm.

	(#17)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	02.19.2007, 05:28 PM It's not hard to dremel a flat spot on the shaft. Just make sure the bearing and screw holes are covered so metal dust doesn't get in there. I just held my Neu shft with two fingers and used a small sanding drum on the dremel. Took about 1 minute. IIRC, If you re-wire the LMTs from D to Y, you reduce the kv by a factor of 1.73 (I think). This allows you to run higher voltage in Y, and lower voltage in D and keep the same rpm.