RC-Monster Forums - View Single Post

HotnCold · 03.20.2007, 05:02 PM

I have a harbor freight micro mill (which I no longer use )- and mike and i have spent some time on her - brand new table - also cnc controlled with servos on all 3 axis, reversible spindle - 4000 rpm spindle conversion, and a bunch of other stuff - and it worked quite well. I might put this on ebay - i could use the extra room for more aluminum stock - lol. She worked well when i used her - but i downgraded to a smaller lighter mill now - as long as you take your time and go easy - then this type of mill is not a bad investment - the money comes into play with the cnc controller and steppers or servo motors... Good luck on your quest....

	(#20)
HotnCold RC-Monster Admin Offline Posts: 1,065 Join Date: Dec 2004 Location: RC-Monster Store....Where else?	03.20.2007, 05:02 PM I have a harbor freight micro mill (which I no longer use )- and mike and i have spent some time on her - brand new table - also cnc controlled with servos on all 3 axis, reversible spindle - 4000 rpm spindle conversion, and a bunch of other stuff - and it worked quite well. I might put this on ebay - i could use the extra room for more aluminum stock - lol. She worked well when i used her - but i downgraded to a smaller lighter mill now - as long as you take your time and go easy - then this type of mill is not a bad investment - the money comes into play with the cnc controller and steppers or servo motors... Good luck on your quest.... Hows that "Hope and Change" working out for Ya???