RC-Monster Forums - View Single Post - Revo Slipper on E-Maxx Tranny Mod :)

MetalMan · 04.05.2007, 01:18 AM

Just to add, the MGT spur gears will still need to have the center hole bored out to fit a 5x10mm bearing. It's only a little bit, but I never had any luck fitting the bearing without doing so.

	(#8)
MetalMan RC-Monster Mod Offline Posts: 5,297 Join Date: Mar 2005 Location: SoCal	04.05.2007, 01:18 AM Just to add, the MGT spur gears will still need to have the center hole bored out to fit a 5x10mm bearing. It's only a little bit, but I never had any luck fitting the bearing without doing so. SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz