RC-Monster Forums - View Single Post

MetalMan · 06.30.2005, 04:02 PM

I haven't seen anything that would be a direct fit for a T3. I also don't know if the T3 axle is long enough to accept a hub, since the regular wheels don't use a hub, just a pin. If you could put the adapter for Maxx wheels to be used, there would be a little slop since the 'Pede uses a 5mm axle, and the T3 uses a 3/16" axle (4.76mm). It could be done though! If you were also thinking about the front, well that would be a little more complicated.

	(#2)
MetalMan RC-Monster Mod Offline Posts: 5,297 Join Date: Mar 2005 Location: SoCal	06.30.2005, 04:02 PM I haven't seen anything that would be a direct fit for a T3. I also don't know if the T3 axle is long enough to accept a hub, since the regular wheels don't use a hub, just a pin. If you could put the adapter for Maxx wheels to be used, there would be a little slop since the 'Pede uses a 5mm axle, and the T3 uses a 3/16" axle (4.76mm). It could be done though! If you were also thinking about the front, well that would be a little more complicated. SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz