RC-Monster Forums - View Single Post - e-maxx tranny slippen again... kinda...

Gustav · 09:14 PM

You can just take the 1st gear idler out(little one in the middle),but leave the shaft in,and leave the 1st gear output gear and bearings in as a spacer.
so if you use the g-maxx coupler,only thing to go in is the coupler and only thing that needs to come out is the 1st gear idler gear.i think that's right.

	(#13)
Gustav RC-Monster Aluminum Offline Posts: 916 Join Date: Jul 2005 Location: UK	04.05.2007, 09:11 PM You can just take the 1st gear idler out(little one in the middle),but leave the shaft in,and leave the 1st gear output gear and bearings in as a spacer. so if you use the g-maxx coupler,only thing to go in is the coupler and only thing that needs to come out is the 1st gear idler gear.i think that's right. Last edited by Gustav; 04.05.2007 at 09:14 PM.