 |
|
|
|
|
|
 |
 |
ezrun 150A |
 |
|
 |
|
(#1)
|
|
RC-Monster Carbon Fiber
Offline
Posts: 118
Join Date: Sep 2008
|
ezrun 150A -
04.24.2009, 07:00 PM
How I need to configure the ezrun 150A??? it is going to run my e-maxx with a neu 1515 2.5d
it is the programmable items: http://www.hobbywing.com/upload/car/...zrun80_e_s.jpg Regards |
|
|
|
 |
 |
 |
|
|
|
|
|
|
(#2)
|
|
RC-Monster Carbon Fiber
Offline
Posts: 212
Join Date: Feb 2009
|
04.24.2009, 09:09 PM
Start with default settings and see how it runs. You do not need to adjust timing as delta-wound motors are insensitive to timing changes. Do NOT adjust punch to "0". I wouldn't go below "3". Set your Low Voltage Cutoff for LiPos if you use them. Aside from that, you're fine.
|
|
|
|
|
|
|
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Linear Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
