Programming question - RC-Monster Forums

nitrostarter · 01:16 AM

I have the BK18120 and I was wondering if there were different programs that regulate the output of the motor. I remember the Hacker controllers had this option so I was wondering if the BK's were the same. If so, what are they and what do I need to do? Also I have no brakes. My maxx has to roll to a stop before it'll go in reverse.

And also, would 16cells on the 9L with the 18120 controller be pushing it or what?

squeeforever · 01.24.2006, 09:16 AM

16 cells on the 9l will shorten its life and isnt recommend because you would be pushing the limits of the motor.

RC-Monster Mike · 01.24.2006, 10:34 AM

If you don't have brakes, you are probably not in car mode. Try re-programming it. The controller can take 16 cells, but the motor will be overworked.

coolhandcountry · 01.24.2006, 10:35 AM

I have not found this current limiter. They have some parameters you can change. I am not sure if this would help you or not. You need the program cable for this. Are you running the micro or warrior.

nitrostarter · 01.24.2006, 08:38 PM

I'm running the micro version. If I'm not in car mode how do it program that? I did the program method as stated in the sticky post up top of the BL section.

coolhandcountry · 01.24.2006, 08:54 PM

not program mode. It is a program cable. I find it in the shop and post it for you. Show you what you need.

coolhandcountry · 01.24.2006, 09:34 PM

http://www.rc-monster.com/proddetail...prgcble&cat=21

here is that cable dude.

nitrostarter · 01.25.2006, 08:32 AM

Does this cable come with a program or anything? It says just the cable. I'm not that technologically advanced. Any english version?:D

coolhandcountry · 01.25.2006, 09:08 AM

http://www.bk-electronics.com/
here is the site you need to go to.
Up top is a general technology.
Then software download will apear.
Download what you need. Micro or warrior controller software.