Hybrid diff output questions

[lincpimp]

So I have an older set of hybrid diffs. These are the ones that can accept a std unmachained pinion. I have all of the bearings etc, but want to run std revo sliders. I am pretty sure you can make the output for the diffs by cutting or modding revo axle shafts. AM I correct?

I looked at the instructions, but they were for the V3 and I must have V2 or 1.

Thanks

[Arct1k]

Mike IIRC sold custom machined outputs to mate with stock sliders or you could try just drilling them out...

[lincpimp]

Have a pic? I have a few sets of the revo axles, just can't remember what to do to them.

Had a look, seems like you can just cut the threads off the stub axles and be good to go. I will have to dig out some sets and see.

Also, can we use losi diffs from the lst in these cases?

[George16]

You can just cut off the threaded portion. I did this before going cvds and universals on my UE trucks.

[lincpimp]

Yes, I found a excellent writeup with pics from our own mistercrash!!! Those canadians are ok, regardless of what I have said in the past!!!

[mjosparky]

Originally Posted by lincpimp

Yes, I found a excellent writeup with pics from our own mistercrash!!! Those canadians are ok, regardless of what I have said in the past!!!

Well are you going to give us a link or make us hunt it down our selves?

Sparky

[lincpimp]

Originally Posted by mjosparky

Well are you going to give us a link or make us hunt it down our selves?

Sparky

Yes, to both.