MT3/MaxxMulcher Render

so while I continue to wait for my LSP in the mail.. (03-21-2007 3:53 pm Shipped from ultimatehobbies).. I figured I'd make the wheels/tires i'll be running. still not done w/ small details (threads on the hex nut, and i need to make offset spikes for the tire)

Proline MaxxMulchers on Ofna MT3 rims (Dominator):



I wish i could play with the settings more, but to get decent quality with all those spikes, it takes about 15 minutes to preview the render.. $300 for 4GB of RAM =\

[jollyjumper]

sweet man.

yay



two things i forgot..
the 17mm hex's.. luckily, i have the ones from my hyper7pro
and my neu is a 1215.. because the 1515 i wanted was out of stock when i bought the motor.. think a 1215 2.5d would be ok until I buy a propper motor?

oh and need to remember to pick up a set of upper a-arms at the lhs tommorow as well.

[Mike.L]

I see that many more have the lsp-r now! Going to be definatly another good conversion.

[skellyo]

Don't forget a Kyosho spur! I don't see it in the pic anywhere.

Originally Posted by skellyo

Don't forget a Kyosho spur! I don't see it in the pic anywhere.

there's a possibility, i won't be using a center diff..:005: