 |
|
|
|
|
|
 |
 |
NEU motor question |
 |
|
 |
|
(#1)
|
|
Guest
Posts: n/a
|
NEU motor question -
09.07.2008, 03:42 PM
are you guys grinding a flat on your NEU motor shafts for the pinions or is locktite doing ok holding the pinions on ?? thanks for the help
|
|
|
|
 |
 |
 |
|
|
|
|
|
|
(#2)
|
|
That's All Folks!
Offline
Posts: 2,359
Join Date: Dec 2006
Location: in a VAN down by the RIVER
|
09.07.2008, 04:32 PM
Most will put a flat spot.
|
|
|
|
|
|
|
|
|
|
|
|
|
(#3)
|
|
RC-Monster Brushless
Offline
Posts: 2,077
Join Date: May 2007
Location: Australia
|
09.08.2008, 02:03 AM
The new Neu motors come with a little flat spot but doesn't go along the whole shaft. Stick the motor in a bag and poke a hole through it with the shaft (this will keep any debris getting in the motor) and then use a dremel or file to make a flat spot
MMM V1 w/1.20 Airtronics MX3 2.4Ghz TP 5S 5000mah Neu 2.5D/F |
|
|
|
|
|
|
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Linear Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
