RC-Monster Forums  

Go Back   RC-Monster Forums > RC-Monster Area > General Discussion

Reply
 
Thread Tools Rate Thread Display Modes
need computer help quick!!
Old
  (#1)
t-maxxracer32
RC-Monster Brushless
 
t-maxxracer32's Avatar
 
Offline
Posts: 2,184
Join Date: Nov 2006
need computer help quick!! - 04.16.2009, 12:01 PM

hey guys i have 2 research papers due by the end of the day and for some reason i woke up and my computer had this message on the screen

windows could not start because the following file is missing or corrupt
\system32\ntoskrnl.exe.
please re-install a copy of the above file.


what the heck is wrong!?!?

i used the computer last night and left it on like i usually do..


thanks for any help!! need to get it working by the end of the day
   
Reply With Quote
Old
  (#2)
Arct1k
RC-Monster Mod
 
Arct1k's Avatar
 
Offline
Posts: 6,597
Join Date: Apr 2007
Location: NJ
04.16.2009, 12:11 PM

NTOSKRNL.EXE is missing or corrupt.

Related errors:

Below is a listing of the full error message that may be related to this error.

Windows NT could not start because the below file is missing or corrupt:

C:\Winnt\System32\Ntoskrnl.exe

Cause:
Keyboard issue
Miscellaneous corruption
Corrupt boot.ini file.
Missing boot.ini file.
Missing or corrupt ntoskrnl.exe file.
Windows NT installed on a partition bigger then 7.8GB
Corrupted hard disk drive or severely corrupted Windows.
Solution:
Keyboard issue

This issue has also been known to be caused by a short in the ground wire in the keyboard cable. Make sure this is not the cause of your error by replacing the keyboard with a different keyboard or simply just disconnecting the keyboard from the computer.

Miscellaneous corruption

Before trying any of the below recommendations it's recommend that you attempt to load the last known good configuration. Additional information about doing this can be found on document CH000626.

Corrupt boot.ini file

This issue is often caused when the boot.ini is missing or improperly configured. This issue often arises after a user has recently added or removed an operating system on the computer or added or removed hard disk drives in the computer.

Make sure the line pointing to the operating system and it's drive and partition is properly configured in the [boot loader] and [operating systems] section. Additional information about boot.ini can be found on document CH000492.

Missing boot.ini file

Microsoft Windows XP users:

If the boot.ini is severely corrupted or missing a user running Microsoft Windows XP can rebuild the boot.ini to resolve this issue. Additional information about rebuilding the boot.ini can be found on document CH000648.

Microsoft Windows NT and Windows 2000 users:

To restore the original boot.ini file in Microsoft Windows NT or Windows 2000 you will need an ERD and follow the below steps. If you do not have an ERD you will be unable to follow these steps.

Boot the computer with your Windows NT three setup diskettes or the Windows 2000 setup disc.
In the setup menu, type R to start the repair.
When prompted for the ERD diskette insert the diskette and inspect the startup environment.
Missing or corrupt ntoskrnl.exe file

If the ntoskrnl.exe file is corrupt or missing this can also generate the error. To restore this file follow the below steps.

Insert the Microsoft Windows XP CD. Note: If you have a recovery CD or a restore CD and not a Microsoft Windows XP CD it is likely the below steps will not resolve your issue.
Reboot the computer, as the computer is starting you should see a message to press any key to boot from the CD. When you see this message press any key.
In the Microsoft Windows XP setup menu press the R key to enter the recovery console.
Select the operating system you wish to fix, and then enter the administrator password.
Type expand d:\i386\ntoskrnl.ex_ c:\windows\system32
You will then be prompted if you wish to overwrite the file type Y and press enter to overwrite the file.
Type exit to reboot the computer.
Windows NT installed on a partition bigger then 7.8GB

If you are running Microsoft windows NT 4.0 on a partition larger than 7.8GB this issue can occur if the boot files are located outside this limitation. When this error occurs your computer will have the error message as shown below.

OS Loader v4.01
Disk I/O error status=00000001
Windows NT could not start because the below file is missing or corrupt: winnt\system32\Ntoskrnl.exe
Please reinstall a copy of the above file.

If your system partition is larger than 7.8GB you will need to delete the partition and recreate the partition to 7.8GB or less. Additional information about this issue can be found on Microsoft KB Q224526.

Corrupted hard disk drive or severely corrupted Windows

Attempt to check the hard disk drive for any errors by running the chkdsk error. To do this follow the below steps.

Insert the Microsoft Windows XP CD. Note: If you have a recovery CD or a restore CD and not a Microsoft Windows XP CD it is likely the below steps will not resolve your issue.
Reboot the computer, as the computer is starting you should see a message to press any key to boot from the CD. When you see this message press any key.
In the Microsoft Windows XP setup menu press the R key to enter the recovery console.
Select the operating system you wish to fix, and then enter the administrator password.
Once at the recovery console type chkdsk /r
Once completed type exit and see if issue is resolved.
If after trying all of the above steps you are still encountering the same issue it's likely that Windows is severely corrupted and it is recommended you attempt to reinstall Windows. Additional information about erasing the computer and starting over can be found on document CH000186.

Finally, if during the Windows installation you encounter errors it's likely that your hard disk drive is bad.
   
Reply With Quote
Old
  (#3)
t-maxxracer32
RC-Monster Brushless
 
t-maxxracer32's Avatar
 
Offline
Posts: 2,184
Join Date: Nov 2006
04.16.2009, 04:49 PM

ok so apparently if you plug in a mouse to the front usb ports (the the ones connected to the mobo) then it will cause you problems lol...

my parents computer (the one that messed up) has a freakin terrible ps2 connnected mouse and so i plugged in my gaming mouse into the front 3 usb ports thinking it would be fine. well when my mom restarted the computer apparently it messed with something.

anyways thanks for your help arct1!! after reading that its probably a keyboard problem i thought what was the last things that i did to it... and i remmeberd about the mouse!!
   
Reply With Quote
Old
  (#4)
_paralyzed_
working on a brushless for my wheelchair.....
 
_paralyzed_'s Avatar
 
Offline
Posts: 4,890
Join Date: Mar 2007
Location: minnesnowta
04.16.2009, 04:57 PM

so often troubleshooting dictates that your problem is relevant to the last thing done by the last user. If everyone started there, there would be a lot less questions


_______________________________________

It's "Dr. _paralyzed_" actually. Not like with a PhD, but Doctor like in Dr. Pepper.
   
Reply With Quote
Old
  (#5)
Arct1k
RC-Monster Mod
 
Arct1k's Avatar
 
Offline
Posts: 6,597
Join Date: Apr 2007
Location: NJ
04.16.2009, 05:10 PM

Glad it helped...

Harrold - Like turning your screen sideways - lol - stay away from the red...
   
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump







Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com