Micro T questions

[eovnu87435ds]

So I picked up a micro T, and when looking around on sites like atomic mods, etc. The truck runs for 7-9 minutes on a 180mah nickel pack. I have also seen that the losi micro xcelorin speed controller is rated for 5 amps continuous, 9 amps burst. I'd think that the stock motor/esc would be less.

What I was thinking, was to take a pair of cellphone batteries, rated at 850mAh, and wire them in series for a 2s li-ion pack. Do you think the batteries will hold up to the stock setup? has anybody ever tried this before?

Or does anybody know the general rating of cellphone li-ion batteries? specifically those from motorola/nextel phones?

[Arct1k]

I would think not cell phone bats designed for v low discharge

[eovnu87435ds]

i thought of that too, and would be using a 2s LVC/LVA to let me know when to recharge and keep them above 3v/cell. I believe thats what the extra little circuitry in the battery did, but I removed all that and will use one made for R/C

[simplechamp]

Regardless of what LVC you use you'll need a rating of at least 10C burst if using 850mah cells with stock electronics.