e-maxx dual steering on flm chassis

[_paralyzed_]

I was looking at the new e-maxx dual servo steering setup and my flm e-maxx chassis and I eyeballed them both real real good. It'll fit. Will someone put the new steering setup in an flm chassis and rell me how it works?

Much to my surprise, it is a direct bolt on. Not one thing is needed for it to bolt right up. The only thing it required was one bell crank standoff, in which comes in the FLM chassis.

[_paralyzed_]

huh, so I eyeballed it right! Now fastlane needs to make a little plate to mount the new e-maxx tranny to the existing chassis, driveshafts and everything should swap right over

[_paralyzed_]

after further eyeballing a simple plate to go over the tranny hole will work, attach it with the original tranny mount holes and cut out the proper hole for the new tranny, should be a simple, well received money maker. you can pay me later

We are actually redesigning 2 new chassis'. One to race and one to bash. Or both. It is still in the design phase right now.

[A RC Dude]

Originally Posted by Fast Lane

We are actually redesigning 2 new chassis'. One to race and one to bash. Or both. It is still in the design phase right now.

so do you work at fast lane?

[neweuser]

I think his name is Jamie

[Serum]

it's more of Jamie..

[neweuser]

Well, thank god I'm not an English or name spelling scholar!

Good to see you Serum.

[Serum]

I'm still around Troy!

It's good to see you after such a long time.! I even went to the US last year to pay the Monster a visit. Jamie was there too. We had a great time.

[neweuser]

Originally Posted by Serum

I'm still around Troy!

It's good to see you after such a long time.! I even went to the US last year to pay the Monster a visit. Jamie was there too. We had a great time.

I know you were, the only bad thing is that I could not make it last year! :( It ticks me off too that I could not make it. I made it the year before. :)