Which Revo Center CVD fits the Hot Bodies Pinion Cup?

[sikeston34m]

Originally Posted by lincpimp

You have the hb cup correct? It is 8mm, as is the pinion shaft (makes sense as they are designed to fit together). The ths cvds have a larger ball than a std revo/maxx cvd. You could drill the included ths cup out to 8mm and us it in place of the hb cup. Not sure if there is enough material left for the set screw to hold though. Nothing like a little "interface" issues to really get you aggrevated, huh?!

Uh huh

The THS cups use a smaller set screw and the cups are longer. I think that would bring other issues, even if I am able to drill them. That's some really hard stuff.

My first thought was to drill the HB Cup to 9mm where the ball goes. Titanium barely scratches it, so I stopped after just scratching it. LOL

Mike just told me the Savage Cups use the larger CVD balls. In looking around, I notice there are two different sizes of them.

Will this one work?

http://www3.towerhobbies.com/cgi-bin...?&I=LXDLG0&P=7

That's the wrong picture. Take a look at the "purchase screws separately" link. Those are 5mm thread.