Looking at those adapters, my guess is that they wouldn't be as good as the Prolines. They use the same drive method where the 23mm hex is driven by the pin through the axle. The fact that they use the same stock axle nut to hold them on is weak IMO. I think this drive pin is what Serum was referring to coolhand.
As coolhandcountry said, the Dace will work with many CVDs or even the stock sliders because the Dace fits over the 14mm nut. The adapters you linked or the Proline will only work with shafts that have the pin through the axle. UE drive axles have flats to drive the 14mm nut instead of a pin through them. So if you are running UE CVDs or plan to, I'd say the only way to go is Dace.
Threaded Mode
