BLMT2 project [solidworks WIP] - RC-Monster Forums

		RC-Monster Forums > Support Forums > General Electric
BLMT2 project [solidworks WIP]

Rate Thread

Prev

Previous Post

Next Post

Next

	(#11)
A4DTM Guest Posts: n/a	11.09.2005, 02:16 PM bump because it's sexy now just gotta finish making a few holes here and there, then the test pieces will be cut out of lexan to make sure everything lines up properly. two screws will go through the top deck, the rear brace, and into the diffcase's holes.. no modifications needed to the stock diff cases :)

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Forum Rules

Forum Jump

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com