 |
|
|
|
|
|
 |
 |
 |
|
 |
|
(#10)
|
|
Guest
Posts: n/a
|
04.15.2012, 10:09 PM
Thank you. I will share the build in the near future.
There is so little material to remove from the carrier. I used a 1/8" straight cutter, and just took off the edge around the carrier (kinda a chamfer) so the bearing would start into the carrier. Then pressed it into place. Kirk |
|
|
|
 |
 |
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Threaded Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
