RC-Monster Forums  

Go Back   RC-Monster Forums > Support Forums > General Electric

 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old
  (#11)
A4DTM
Guest
 
Posts: n/a
07.06.2006, 10:08 PM

bp, i think the 9l is a low enough turn. i don't want to run a 10s lipo pack, but at the same time, i don't know if a lower turn motor would have enough torque.. I think a 9L geared right will be just fine.. if it's not.. lower turn, is always a possibility. I'm going w/ what i have right now, as I don't have an unlimited bank to buy multiple motors, ect.

dafni, I'm thinking about it.. seriously..

jt, the reason for 4wd is stability. I've run rwd above 50mph before, and it was alot more nerve racking than a 4wd at the same speeds. I've got a XS3, so exponential steering throttle, ect is possible, and will be used. I've also got a few ideas as far as aero goes.. a full left side wall is what i'm planning at the moment.. similar to to sprints, but I've seen it work wonderfully on 1:1 cars.. when this project gets further under way, I'll explain it better.

jhautz, video is obvious :)

mike, I'm familiar w/ a nitro 4tech, but what's the 3.3?
   
Reply With Quote
 


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump







Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com