RC-Monster Forums  

Go Back   RC-Monster Forums > Support Forums > Mini truggy

 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old
  (#11)
BrianG
RC-Monster Admin
 
BrianG's Avatar
 
Offline
Posts: 14,609
Join Date: Nov 2005
Location: Des Moines, IA
03.23.2007, 06:16 PM

I don't have much luck with tapping threads into aluminum for some reason. Plus, being only 3.5mm 6061, I'm concerned about the threads holding up. At any rate, I don't want to rebuild the mount simply to have tapped holes. :) The top of the motor doesn't even go as high as the top of the diff mount so it shouldn't be too bad. If anything, I'm more worried about my batteries because they are going to have to sit in there edgewise to fit, which will make them quite tall...
  Send a message via Yahoo to BrianG Send a message via MSN to BrianG  
Reply With Quote
 


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump







Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com