Another Brushless REVO conversion

[Shark413]

RC, those pictures were taken a while back and no I didn't get any track pictures. But the next time I go I will try to get some pictures and video. I filmed video of my nitro truggy but forgot about the Evo because I was having so much fun with it. Since the pictures above I have gone back to the stock Revo truck body so everyone knows what I am driving. I have also added the following:

Tekno extended wheelbase rear a-arms
Hitech HS-985MG steering servo.
Single steering servo mod
Steering Mod
Alloy parts for all shocks (caps, spring retainer, rod ends)
Alloy tie rods and push rods
Removed one spacer from push rod to lower the chassis
Close ratio gears and FOC
Spektrum receiver and telemetry module
50wt & silver springs front, 60wt & blue springs rear
RPM carriers
Novak HV 4.5 motor
Alloy pivot post
Ti pivot balls
23mm hubs