I have the only Cell Shield (by Dimension Engineering) that is compatible with cars, but I don't use it. It has a few issues that wouldn't be noticed in an airplane, but are annoying for car use. I was told that this item would be produced if the demand were large enough, but it seems this project fell off the map when I stopped receiving replies from Dimension while I was testing it.
SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz
MetalMan, can you tel what issues?
Becouse i bought that http://www.dimensionengineering.com/LipoShield.htm
Now I am little bit worried :(
I have tested it on Plane it works good but what issue on car?
Is it Reverse issue?
I tried that dimension engineering one once and it just cut out randomly. The voltage on the batteries was well above the cut off and it would just stop. I didnt reall goof around with it to much to figure out why. I just switched to the one Mike sells in the RCM store. It works well enough. Just cuts the throttle when the voltage drops. Simple, no bells and whistles, but it works.
I can't decide if its more fun
to make it...
or break it...