 |
|
|
|
 |
|
|
 |
 |
|
 |
|
(#1)
|
|
Guest
Posts: n/a
|
05.03.2007, 04:38 PM
Is a flat spot enough? I've had my shaft's dimpled so the set screw goes into the shaft a little bit...Gotta be real careful to give the right depth before it gets drilled...I would like to use a flat spot but I heard it's not enough with these high power setups.
DM |
|
|
|
 |
 |
 |
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Hybrid Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
