 |
|
|
|
 |
|
|
 |
 |
|
 |
|
(#1)
|
|
RC-Monster Dual Brushless
Offline
Posts: 3,794
Join Date: May 2005
Location: georgia
|
06.02.2007, 12:02 PM
If the magnet is whole and not busted, try JB Weld on it. I had a novak hv 4400 that the magnet seperated and it worked great on that. The light scuffing that you did will help a lot in adhesion
People here hate Nitro, I love it. I start it, run it about 50 ft from me and it dies, I go after it. Perfect exercise |
|
|
|
 |
 |
 |
|
|
|
|
|
|
(#2)
|
|
RC-Monster Carbon Fiber
Offline
Posts: 81
Join Date: Jun 2007
|
06.02.2007, 11:27 PM
Well, I took it apart again and tried the JB weld thing. It's definitely one solid magnet on the shaft. We'll see how it goes in a day or two. I also decided to replace the bearings while I was at it because one of the originals was feeling a bit crunchy. If it comes loose again I'll probably go with the 1512 2.5D.
|
|
|
|
|
|
|
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Hybrid Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
