 |
|
|
|
 |
 |
 |
|
 |
|
(#2)
|
|
RC-Monster Carbon Fiber
Offline
Posts: 200
Join Date: Jan 2007
|
10.09.2007, 02:51 PM
Really no one has any ideas ?
To make it a bit more clear, after the bearing replacement I can push/pull the wheel in and out quite abit, and the axel (in where I put the wheel nut on) is moving so it not just that I havent tighten the wheel nut. Any ideas at all if shimming is needed or if this is "another" problem ? |
|
|
|
 |
 |
 |
«
Previous Thread
|
Next Thread
»
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
Threaded Mode
|
|
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
Copyright ©2000 - 2026, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com
