Help with a Plettenberg please!

[aqwut]

Originally Posted by BL-Power

???



I asked Plettenberg and they told me that the Maxx has 4 Poles and the BigMaxx 6 Poles!

Right on...

[skillx]

I have been running my MM/BigMaxximum setup a little over 8 months now with no issues. I think from what I am reading your issue may be with the connecters. Try cutting the connectors completely out of the loop by hard wiring the ESC to the motor and see if the cogging issue persists.

My 2 Cents...

[aqwut]

Originally Posted by skillx

I have been running my MM/BigMaxximum setup a little over 8 month now with no issues. I think from what I am reading your issue may be with the connecters. Try cutting the connectors completely out of the loop by hard wiring the ESC to the motor and see if the cogging issue persists.

My 2 Cents...

Cool.. I did not know this was possible.... that's sweet....

[ilpufxit]

I'm going to try hardwiring first. If that still isn't it, I'll try the Quark. I was really hoping to run the MM since I have an extra one. Any input from other MM users on the best settings?

[jordan...]

how many cells are you running with that setup skillx?

[skillx]

Originally Posted by jordan...

how many cells are you running with that setup skillx?

4 now because I have a newer MM. But when I had an older MM i ran 5 all the time with no issues.

[ilpufxit]

I finally got back to this project. Using the Plettenberg, I swapped in my Quark 80b and the same cogging and extreme heating up occurs. I'm now convinced that there's something like a short in the motor. I have no continuity to the case on any wire but the heat build up is so fast that it could really only be a short.

BTW, with my feigao 8xl in the same set up with the MM, there is a little bit of cogging on start. Not much, but enough so you can't just grab WOT. With the Quark 80b, the cogging completely stops. Much smoother.

Is there anyone in N America who can fix this motor?