My Emaxx 3905 Vtwin With Pictures

[lincpimp]

Looks cool, wonder if those two motors are as powerful as a KB45xl on 6s? We shall see! Here is the calc with the 2 speed in 2nd gear, 1st should be good for 40 mph! I think the KB motor will pull the speed, just wonder what esc to use?

Differential Ratio: 3.3076923076923075
Transmission Ratio: 1.16
Spur Tooth Count: 48
Pinion Tooth Count: 20
Total Voltage: 22.2
Motor KV: 1700
Tire Diameter (inches): 5.75
Total Motor Speed: 37740 RPM
Vehicle Speed: 70.11 MPH

[sikeston34m]

Originally Posted by lincpimp

Looks cool, wonder if those two motors are as powerful as a KB45xl on 6s? We shall see! Here is the calc with the 2 speed in 2nd gear, 1st should be good for 40 mph! I think the KB motor will pull the speed, just wonder what esc to use?

Differential Ratio: 3.3076923076923075
Transmission Ratio: 1.16
Spur Tooth Count: 48
Pinion Tooth Count: 20
Total Voltage: 22.2
Motor KV: 1700
Tire Diameter (inches): 5.75
Total Motor Speed: 37740 RPM
Vehicle Speed: 70.11 MPH

Linc!

You mean you have a KB45 up your sleeve?

[lincpimp]

Originally Posted by sikeston34m

Linc!

You mean you have a KB45 up your sleeve?

I have 3, a 10xl 8xl and a 10l, just can't beat the prices, I also have pinions with 6mm bore in 18t and 20t. They are only good for a plastic spur thought, not hardened. I have also had mike make me a 2 speed adapter with 6mm bore for my aftershock/lst project. I will run it with the 10xl (1200kv) on 9s lipo thru a cc hv85! Stock gearing gets me to 47mph in second, and doing the tranny gear swap should get me over 50. The lst is a big truck and 50mph should be fun! I think that the emaxx will get the 8xl and 6s lipo. Not sure what esc to use!