How do I use mech. brake w/ tekno conversion?

[raptor50]

yep i tried that still nothing works.. its worse than b/4.. I put the bec in channel 3 and esc in 2 w/o taking out the red wire. when I did that, all worked except that i didnt know where to put the brake servo.. now, when i put the esc w/ red wire taken out and the bec in batt. channel, and the brake servo on 3, the bec, lights up with green light, but steering and throttle doesnt respond.. on the diagram that came w/ the bec states nothing about taking out the red wire, and states putting it in channel 3..

really confused..

[Matthew_Armeni]

Did you connect the bec to the esc power leads? If you're still stumped do you have a rx pack you cann throw in and try that instead of the BEC?

Originally Posted by Matthew_Armeni

Did you connect the bec to the esc power leads? If you're still stumped do you have a rx pack you cann throw in and try that instead of the BEC?

Yep, maybe your CCBEC is toasted. Like said Matthew, try with a reciever pack on the BATT slot. And don't forget to remove the red wire on the ESC cable.

[raptor50]

I got a new bec and did the same thing and no steering and throttle. I hot wired the red w/red wire on the esc along with black and pulled out the red wire in the channel 2 and put the bec in channel batt. what do I do with the on/off switch from the ESC? do I have to hot wire this as well?