MM update is up!

[gixxer]

well I just downloaded it. tried my 8t out in the house with 5s and a 12xl feigao. so far all I notice is the annoying sound at low speed. guess I will have to wait for the woman to get home so I can try it outside (have to watch the little one).

[pb4ugo]

Originally Posted by gixxer

well I just downloaded it. tried my 8t out in the house with 5s and a 12xl feigao. so far all I notice is the annoying sound at low speed. guess I will have to wait for the women to get home so I can try it outside (have to watch the little one).

And I have a hard enough time with one!

[lincpimp]

Ok, just did the downlaod onto the mm in mt ext crt.5. I run a 3s 4200 lipo and a plett maximum. It does start the 4 pole motor better, and the esc seems to run cooler too. I also seem to have better runtime, like 3-5 minutes. Good stuff, can't wait to try thiws update with a aquacraft 6 pole motor in my new emaxx. We will see if it can start that motor, it is impossible to turn by hand! I also have a novak 6.5 that I eill try out in my xxx-cr buggy. Great revision for the best low cost esc around!

Originally Posted by lincpimp

Ok, just did the downlaod onto the mm in mt ext crt.5. I run a 3s 4200 lipo and a plett maximum. It does start the 4 pole motor better, and the esc seems to run cooler too. I also seem to have better runtime, like 3-5 minutes. Good stuff, can't wait to try thiws update with a aquacraft 6 pole motor in my new emaxx. We will see if it can start that motor, it is impossible to turn by hand! I also have a novak 6.5 that I eill try out in my xxx-cr buggy. Great revision for the best low cost esc around!

you have a plett max in a crt .5?

[lincpimp]

Originally Posted by chilledoutuk

you have a plett max in a crt .5?

Yep, makes for a good 3s motor (3100kv) and it never gets much more than slightly warm.