Is there a way improve the LVC shutdown - RC-Monster Forums

Resistance (ohms): Enter the LVC internal resistance, 200,000 in this case.
Capacitance (farads): I used 22uF. Other common values for ~25v are 10uF and 47uF, but don\'t provide the right delay IMO, but that\'s up to you.
Battery Voltage: Self-explanatory. Use the nominal battery voltage. For a 4s pack, use 14.8v.
Time Constants to show: Caps are accepted to be charged/discharged in 5 time constants, but if you want to see more detail in the lower time ranges, use a lower number.
Euler\'s number: This is a constant for natural logarithm base. Leave as-is unless you really want to mess with it.

suicideneil · 02.11.2008, 06:30 PM

For my HvMaxx, it resulted in a cooler esc yeah, but much more punch too from my cheapo Nimhs, especially towards the end of a run. Before the extra cap, the truck (txt-1 back then) would sound like it was trying to change gear every few seconds- revs up... dumps.... revs up..... dumps.... and so-on. Now with the extra cap the Gmaxx just runs smoothly right up until the last few minutes, when it slows right down and I bring her home as it were. I would definately recommend adding another novak cap to the hvmaxx, just wire it in parallel to the existing one and you'll instantly see and feel the improvement. $6-10 on ebay I have seen them for, bargain.