Is there a way improve the LVC shutdown - RC-Monster Forums

Resistance (ohms): Enter the LVC internal resistance, 200,000 in this case.
Capacitance (farads): I used 22uF. Other common values for ~25v are 10uF and 47uF, but don\'t provide the right delay IMO, but that\'s up to you.
Battery Voltage: Self-explanatory. Use the nominal battery voltage. For a 4s pack, use 14.8v.
Time Constants to show: Caps are accepted to be charged/discharged in 5 time constants, but if you want to see more detail in the lower time ranges, use a lower number.
Euler\'s number: This is a constant for natural logarithm base. Leave as-is unless you really want to mess with it.

Gee · 02.17.2008, 10:07 AM

I'm not sure. It was recommeded that I add another capacitor to it and bam there goes my esc. If I could only remember who it was.....

JK it was running fine with the extra capacitor. I had 3 or 4 packs with the extra capacitor installed. Would water shorting out the board cause a melt down like that? I had it out for a run and it was wet out. Didn't wrap it in the usual plastic bag though. Came in and turned it and the controller off. I didn't uplug the batteries though I had to help the nieighbor. Later on I smelled the smoke. So it was quite a while after I had shut it off that this happended. I thought lipo fire at first. Threw those batteries in the barbie outside. The batteries are fine. I had another HV esc do this to me while I was running it. It was bone dry out no chance of water doing it to that one.

Maybe it was me when I added the extra capacitor. If I got the wire too hot adding the other cap. Maybe it worked itself loose from the tabs on the esc. I don't know it sat there for a long time before I noticed any smoke smell.