RCM Heat Sink/Motor Clamp

[Matthew_Armeni]

Here's an XL one on a 9XL Fiegao. I'm not sure about putting it on a Neu though. I don't know if the Dia. is the same for the smooth cans but I think they are. If they are then the L size with some longer screws would fit because the XL Fiegao's are longer than the 1515 Neu's and the XL heatsink goes right to the end of the Neu. I'll check on the can Dia.

[Matthew_Armeni]

Well, I'm finding that the Neu's are 1.56" dia for the smooth can, but I'm also finding that the finned ones are the same? Is that right? I thought they were a little bigger. Either way it's too beg for the heatsink clamp. But the Neu's can lose their endbells, I've seen it happen twice, on the rear endbell, 2 different motors.